Another add here is, there is an issue with the 6 CD drive COg for the ejector being out of sync due to the fact that it is not all the way on and about to come off, or if it is no longer ejecting anything, has already come off. Unplug the power to the radio, this will prepare the unit for a rest when it comes back on for initialization. Take the radio out and remove the top shell, you will have 1 small 2 wire control cable to remove, then open the shell, you will find the cog laying in the unit or in the window to the rear right of the unit where the cogs slide shaft is, it looks like you won't be able to get it back on but you can, with some soft nose needle nose, press the spiral cog back on the shaft until it stops, may take a little force but don't squueze to hard and damage the cog groove, trust me it will go back, I have fixed many of these. be cautions not to rip out the ribbion control cable in this part of the unit while doing this, when putting it back with the lower power amplifier base unit remember to plug back n the two wired cable, after all is put back together plug in the antenna connector firrst then plug the two connectors on the back of the radio inner most first and then out, turn on teh ignition switch and wath the unit you should see it reset or go into initialize, this is programmed in teh prom to check each slot level to update the CD slot indicator I hpe this resolves your problem | 
