workin on it as we speak, gettin all the extremities off . got a lot done yesterday should be in a position to hoist er out today.
Gotta go find a belt for my furnace before I start, it broke last night.
did compression tests yesterday before we started, drove around town for a bit to get the engine up to normal operating temp first.
:each cylinder was not far off from each other.
here's what we got
#1)127.5 psi
#2) 132 psi
#3) 128 psi
#4) 130psi
#5) was a bit low 122psi (double checked it twice, same each time)
#6) 128psi
Not sure what to make of this but I feel good about the fact that they are fairly close to each other , but don't know if this is low or normal?
I have some pics but I'll post em later along with an update. I promise.
Gotta go get that belt , only one place open within an hour of here...
Later and have a good day,
Dave | 
