 do banjo block and banjo bolt need to be aligned?
Hi,
I am in the process of working on my front calipers and was wondering if anybody can clarify the following:
The banjo block has a banjo bolt that goes in it with two
copper crush seals around the banjo block. Two questions:
1) Does the hole in the banjo bolt have to align with the hole in the block? If so, then what is the best method to align those two holes?
2) I tried re-using copper crush washers (gaskets), however found that they would leak. Is it because the holes (question 1) are not aligned or I need brand new copper crush gaskets?
I thank you in advance for any advice you may give me re: this.
thank you | 
