I'm planning to replace the old fogged up headlamp assemblies on the 95 Taurus with new ones from eBay. Seems simple enough, but the little metal retainers are a bit of a pain. Is there a trick/tool I should know about?
I was able to easily remove the top 2 retainers by using snap ring pliers in one hand to spread them and give them a light pry with a small screwdriver in the other hand. However, there's not enough room to do this on the bottom retainers. I'm guessing the Ford guys have a special tool for these goofy clips.??
Any tips would be appreciated!
