1. Open the hood.
2. Push the headlight housing retaining clips rearward, then pull upwards on the clips to release the headlight housing.
3. Pull the headlight housing out and away from the vehicle to access the bulb retaining ring located on the backside.
4. Rotate the bulb retaining ring counter-clockwise as viewed from the rear.
5. Withdraw the bulb assembly and retaining ring from the headlight housing.
6. Remove the bulb from the socket assembly by pulling it straight out.
7. Without touching the glass with your bare fingers, insert the new bulb into the socket assembly and then into the headlight housing, install and tighten the retaining ring.
8. Reposition the headlight housing back into place and install the housing retaining clips. Test headlight operation and close the hood.
Or, if you are using your Expy for the dirt track, just use a hammer. | 
HeadLights 
Linear Mode
