i took a short (very short) drive and found i needed to re-tune. it was too advanced in the timing. so i got that fixed. but while out driving around the block, i ran over a small bump and heard a crunch / grind sound. got it back to the shop and and found the floor boards are toast. ill start a new thread on floorboard replacement this weekend LOL. i got the sheet metal cut today.
someone had actually used bondo to "glue" the floorboard to the rocker pannel. i wanted to beef up the underside anyway.
oh, and BTW, temps are 60-70's here this week, damn its cold!
