Hey, New, and well , need lots off help,

[RedProbeKlze]

Just bought a 93 probe gt, with the klze motor and already having a lot of problems. Have a few loose hoses, around the cold air intake, and not sure were they go, and have a hard time shifting into 1, 2, and rev, when car is warmed up, and today it has oil around the spark plug Lots, witch wasnt there the other day. lol, so could use lots off help, so cant wait to see what this site is all aobut.

[74eldo]

Hello, I had bought a 93 GT I 6 months ago..... pretty much a nightmare to pull the transmission codes as the 93 and 94 probes are pre OBD II codes and use the old ford EEC IV system,nobody has this old software anymore -you can read the engine codes with the OBD II scanner but not the trans. I will get back to you tomorow as you can jump the pins (they are under the hood next to your fuse pannel ) and you will get error codes to flash the fault code on your dash on your O/D indicator. This should help out if you have any transmission faults. As for mine I am getting an 06 error code, wich is the speed sensor. I changed it twice and still no results so I am going to go through the wires and the connector clips to the speed sensor and on the TCM.
I will get back to you as soon as I can......good luck!!!!

[74eldo]

Put a wire on your TAT pin and connect it to the ground pin, this will flash the error code on your O/D light in your dash.
good luck, drop me a pm if you have any more questions.