Ford WindstarIntroduced in the mid-1990s, the front-wheel-drive Ford Windstar minivan campaigned with an emphasis on, and reputation for, safety. And in the hotly contested family minivan market of the time, that was an especially solid piece of ground to be on. As long as buyers didn't need to haul adults in back on a regular basis, the Windstar served a family's needs just fine.
I googled it does cover the 98 windstar. I had that leak, it drips on the harness to the ABS and eventually to the exhaust system also if it is bad. Ford is going to replace the switch, harness, and repair the ABS plug also....under this recall. Funny I wrote this up a year ago and contacted Ford, They Told me there was no problem....Now it is a problem. Yes the pressure switch feeds the cruise control, that is what I first noticed when I lost the cruise control....
It is an extension of recall 05s28 but should not effect the red brake lamp unless it has leaked enough fluid out of the master cylinder rservoir.If you are really worried about itdisconnecy yhe switch like one of the other posters suggested.We have only had 3 at this dealership that caught fire 2 were serious(not windsrtars though)
The recall covers
1995-2003 Windstars
2000-2003 Excursion diesels
1993-1997 and 1999-2003 F-Super Duty diesels
1992-2003 Econolines
1995-2002 Explorers and Mercury Mountaineers
1995-1997 and 2001-2003 Rangers
1994 Ford F53 motor homes.
Ford will notify owners and dealers will install a fused wiring harness. Dealers will also inspect the ABS control connector and repair as necessary. Ford's recall number is 09S09.
Unfortunately, I already changed this out trying to fix my ABS/Brake light on problem with no luck. ** Maybe they will see how many come in with the ABS and Brake lights on and decide to recall on that also.
It is an extension of recall 05s28 but should not effect the red brake lamp unless it has leaked enough fluid out of the master cylinder rservoir.If you are really worried about itdisconnecy yhe switch like one of the other posters suggested.We have only had 3 at this dealership that caught fire 2 were serious(not windsrtars though)
Only 3, huh? I'm just gonna park it in the driveway til tuesday... then the dealership is gonna replace the faulty parts and we should be good to go. the brake light may or may not be related, but that link i posted stated that it illuminating was a symptom of this particular issue... that's what concerned me. if it has a float switch like you say, i feel like that is the most likely cause since it comes on most the time, but not all the time. i'm thinking if my wires were as messed up as the pictures i saw (on that website), it would stay on constantly. but she's still lost her garage privileges til it's fixed! thanks again!
I suspect people here are confusing the brake lights with the brake warning light:
The brake pressure switch on the master cylinder is connected to the ABS and CC.
The brake switch on the pedal controls the brake lights and trailer lights.
Was the Freestar covered by an earlier recall? The brake pressure switches look the same as Windstar, and go intermittent, causing ABS Warn and loss of CC engage. Haven't heard of any leaking, though.
I suspect people here are confusing the brake lights with the brake warning light:
The brake pressure switch on the master cylinder is connected to the ABS and CC.
The brake switch on the pedal controls the brake lights and trailer lights.
Was the Freestar covered by an earlier recall? The brake pressure switches look the same as Windstar, and go intermittent, causing ABS Warn and loss of CC engage. Haven't heard of any leaking, though.
GB
It's my Brake warning light on the dash - red with an exclamation point in the middle - that keeps illuminating... so it IS connected to this faulty part?
Ford Adds 4.5M to Recall
By
Chris Camp
@ October 14, 2009 3:49 AM Permalink | Comments (0) | TrackBacks (0)
DETROIT (AP) Ford Motor Co. said Tuesday it will add 4.5 million older-model vehicles to the long list of those recalled because a defective cruise control switch could cause a fire.
The latest voluntary action pushes Ford's total recall due to faulty switches to 14.3 million registered vehicles over 10 years, capping the company's largest cumulative recall in history involving a single problem.
The recall covers 1.1 million Ford Windstar minivans that had a small risk of fire due to internal leaking from the switches. Ford said in a letter to federal regulators that it found a small number of reported fires linked to the problem during an internal investigation that began last year, but did not specify how many.
The remaining 3.4 million vehicles are Ford, Lincoln and Mercury models. Ford said there were no reports of fires with those models, most of them trucks and sport utility vehicles, but that they were included in the recall because they use the same switches. All vehicles covered by the recall are from the 1992 to 2003 model years.
Ford advised owners of all vehicles covered by the recall to park them outside until they are mailed instructions by the end of the month on how to get repairs.
The Dearborn, Mich.-based automaker has struggled for a decade with the problem, which has prompted hundreds of complaints and dozens of lawsuits over fires allegedly caused by faulty switches. A small number of injuries have also been linked to the problem, though none were reported in the latest recall. Previous recalls included some of Ford's most popular brands, like the popular F-series of pickup trucks.
Ford began an investigation of Windstar vehicles in February 2008 after receiving a growing number of reports of fires under the vehicles' hoods, according to a letter the company sent to the National Highway Transportation Safety Agency late last week announcing the recall. In June 2008, NHTSA began its own probe of the problem.
Investigators found that the switches, made by Texas Instruments, could leak internally, overheat and potentially ignite. NHTSA also identified four reports of leaking fluid damaging the antilock brake control module, resulting in a fire. The module is charged with electrical current and can ignite the fluid in rare cases, said Ford spokesman Wes Sherwood.
Even some vehicles without cruise control are part of the recall because they still have the switches with brake fluid routed through them. To repair the problem, dealers will install a harness to help prevent the fluid from flowing anywhere it could be ignited.
Ford stopped using the Texas Instruments switch in 2003, according to Sherwood. The latest group of vehicles recalled is the last batch still on the road that had the switch installed.
Texas Instruments said in a statement that it manufactured a switch ``to meet and exceed Ford's specifications'' and that it is only one component of Ford's cruise control deactivation system. The company cited a 2006 NHTSA investigation that found multiple factors were to blame for fires. Texas Instruments no longer owns the division that made the switches.
NHTSA spokesman Rae Tyson said Ford ``is to be commended for stepping forward to resolve this issue.''
The recall covers the following model years: 1995-2003 Ford Windstar; 2000-2003 Ford Excursion diesel; 1993-1997 and 1999-2003 Ford F-Super Duty diesel; 1992-2003 Ford Econoline; 1995-2002 Ford Explorer; 1995-2002 Mercury Mountaineer; 1995-1997 and 2001-2003 Ford Ranger; and 1994 Ford F35 Motorhome vehicles.
Shopping for new Ford can be a stressful experience especially if you don't have the right information. Our new car research center at CarEverything.com can help relieve this stress and bring the joy back to new car buying!
The Car Blog, or TCB for those who are acronymically inclined, is alive because some of today's top Web designers needed a place to drool and bitch about their motor vehicle obsessions.
Read the auto blog at Automotive.com to get the latest news and opinions, view the newest concept cars, and join discussions with auto experts from around the world.
I'm just gonna park it in the driveway til tuesday... then the dealership is gonna replace the faulty parts and we should be good to go. the brake light may or may not be related, but that link i posted stated that it illuminating was a symptom of this particular issue... that's what concerned me. if it has a float switch like you say, i feel like that is the most likely cause since it comes on most the time, but not all the time. i'm thinking if my wires were as messed up as the pictures i saw (on that website), it would stay on constantly. but she's still lost her garage privileges til it's fixed! 
Linear Mode
