Governor removal.

[escortinglove88]

I was wondering how the cup holders actually came out or if they would break or snap while removing them. Do I just remove the inner piece of the console? Could someone post a picture or something of what it looks like with the actual cup holders out and the wires showing?

[svtzx2]

just pull it out

[escortinglove88]

Thanks I got it. The engine light stayed off for a while but then it came on, is there any way to bypass the light and is it safe to drive the car over 120? I buried my needle and it was not really close to the redline. I like my zx2 it's fun.

[zxtwo]

i heard when the service engine light comes on, your car' doesn't put out its potential power cause it goes into like a safe mode until its fixed. but i dont know thats what i heard.

[svtzx2]

if you put it on a switch you can just turn it off when you need to and the turn it back on like when i race i go over 105 so i flip the switch and when im done i turn it on lol works

[kraZx2]

Originally Posted by svtzx2

if you put it on a switch you can just turn it off when you need to and the turn it back on like when i race i go over 105 so i flip the switch and when im done i turn it on lol works

my question is how do you put your service engine sensor or governer on a switch. my zx2 wont go past 110 and my service engine light has never been on.

[darksteel89]

Buy a simple On/Off switch from auto store or even walmart, cut the governor wire, connect one end to one side of switch, the other the the other side. Voila! Keep it on off when you arent going over 100 mph and turn it off after your done racing.