BroncoJoe19

I'm in North Jersey, and I had called a couple of AutoZones, and neither would scan OBD-1 systems. Others on here have said that AutoZones near them will scan OBD-1 cars and trucks. However with a four inch piece of wire and the ability to count to ten, a person can pull codes on OBD-1 systems for free.

How to scan FORD on board Diagnostic Trouble Codes (DTCs) in your driveway
Howto Pull Codes 1983-1995 Broncos, Mustang, F series Trucks, Econolines, 302, 351 and more

Can autozone not scan obd-1?

http://www.ford-forums.com/engine-dr...-help-pls.html

Could you please take another look at this? I am having difficulty getting into gears and when I pump clutch many many times I have some success and it works better in warmer weather.

Should I try bleeding clutch? If so how do I do it?

Thanks

Hey Joe, do you think you could walk me through how you check an engine with wire? I got a 93 t-bird lx 3.8 v6, non sc. Thanks

please post in the engine and drivetrain section so that more people can help. When you do, please explain how you know the coil pack is good.

Hello, I have an '89 Ranger. The intake coil pack isn't firing. The pack is good. I've been told everything from control module to fusable links. I really need some help. It's been 5 days now and a couple hundred dollars. Thanks, p.a.

Larry,
I think you are referring to the heater bypass hose.

Hello Joe, I just blew a heater hose on my 95 Windstar LX 3.8. This is the long hose that goes from the fitting beside and a little higher than the main cooling hose going to the thermostat. Advance, Autozone, and NAPA can't seem to find it. Even the local Ford dealer cant seem to understand what I am describing.

Do you have any way of getting a part number?

Thanks,

Larry McNeely

hey joe i sure hope ;you can help me. someone stole all my parts off the front of my 92 bronco 302. i need to replace them and have found 351(93f150 351) that i can get the brackets and all (p/steering pump, a/c comp., alternator and pump for smog, pulley for main shaft, pulley for w/ pump. do you know if the 351 parts will bolt to a 302

just a thanks for responding to my posts!